Double Eye Cable Grip - Flexi/Thimble

Double Eye Standard cable pulling grips can be used wherever previously laid cables need to be pulled without having to further reposition the cable winch of the cable. In this manner, regulatory as well as alignment operations can be performed easily.

The cable is inserted through one end of the cable grip via its mouth and comes out through the other end of cable grip. This provides a firm grip throughout the entire length of the cable.

Double Eye standard cable grips can be used to pull light to medium loads, wherever the cable is required to be passed through the grip. Sometimes a thimble is installed near the eyes of the grips to provide extra durability. These cable grips are devised to fit a metric range of cables having longer lattice length. A flexible double eye construction allows the cables to be pulled, to easily pass through the grip. These cable grips can even pull heavy cables and sometimes several cables at the same time.

Double Eye Cable Pulling Grips can be effectively used with or without an integrated thimble for any cable laying operations by trench contractors, for mining operations, in oil and gas industry, as well as marine and offshore operations.

Full specifications are given in the table below.

Part No. Cable Diameter(mm) Permissible workload with a 3 Times higher security load(kn) Lattice Length Approx Total Length Approx
HEK 10/2 6 – 10 2.2 600 800
HEK 15/2 10 – 15 3.4 600 800
HEK 20/2 15 – 20 6.8 600 800
HEK 25/2 20 – 25 6.8 600 800
HEK 30/2 25 – 30 8.1 1,000 1,200
HEK 40/2 30 – 40 11.7 1,250 1,450
HEK 50/2 40 – 50 16.0 1,250 1,450
HEK 60/2 50 – 60 16.0 1,500 1,800
HEK 70/2 50 – 60 21.3 1,500 1,800
HEK 90/2 70 – 90 27.9 1,500 1,800
HEK 110/2 90 – 110 34.9 1,500 1,850
HEK 130/2 110 -130 34.9 1,500 1,850
HEK 160/2 130 – 160 42.7 1,500 1,850
HEK 200/2 160 – 200 49.8 1,500 1,850