Lace Up/Open Type Cable Grips
Open type / Lace up Cable Support grips can be effectively used for supporting cables and hoses efficiently once they have been laid. They can support the outer cable jacket at any desired point.
One advantage of open type/ lace up cable support grips is that you don’t need to disconnect the cables that have been previously connected for attaching these stress relieving grips.
They can be ideally used to pull light to medium loads. An L-type cable grip can be stitched and fitted to the cable that needs to be pulled. Mainly these grips are used at the end of a cable wherever it is difficult to fit a typical cable grip. These open type/ lace up grips can ideally support at several support points throughout the same cable length in cases where it is difficult to access the cable ends.
Full specifications are given in the table below.
|Part No.||Cable Diameter(mm)||Permissible workload with a 3 Times higher security load (kn)||Lattice Length Approx||Total Length Approx|
|HL 6||4 – 6||0.6||100||275|
|HL 9||7 – 9||1.1||120||290|
|HL 12||9 – 12||1.3||135||340|
|HL 15||12 – 15||2.1||180||390|
|HL 19||15 – 19||2.6||220||450|
|HL 25||19 – 25||2.6||275||510|
|HL 30||25 – 30||4.0||350||610|
|HL 40||30 – 40||5.8||370||660|
|HL 50||40 – 50||8.0||490||800|
|HL 60||50 – 60||8.0||500||810|
|HL 70||60 – 70||10.6||520||860|
|HL 90||70 – 90||13.9||580||950|
|HL 110||90 – 110||17.4||650||1130|