Single Eye Cable Grip - Flexi/Thimble

Standard Cable Pulling Grips provide a protective sheath over cables that facilitates easier installation via ducts, conduits, pipes, or risers. This saves a lot of valuable time and cuts down on cost by facilitating easy installation of standard and multi-fiber cables.

The Cable grips relieve the strain directly onto the outer jacket of the cable while keeping the terminations underneath a protective sheath. Due to this, the terminations do not experience any stress or strain during the process of cable installation. Cable grips can be applied for any cable laying mechanical operations that involve large traction forces.

Single Eye Cable Pulling Grips can be effectively used with or without an integrated thimble for any cable laying operations by trench contractors. Single Eye Cable Pulling Grips can be used with a wide spectrum of cylindrical materials ranging from ropes and M.S. Pipes to P.V.C Rigid Pipes during the installation, manufacturing process, or handling operations.

Full specifications are given in the table below.

Part No. Cable Diameter(mm) Permissible workload with a 3 Times higher security load(kn) Lattice Length Approx Total Length Approx
HEK 10 6 – 10 2.2 600 700
HEK 15 10 – 15 3.4 600 700
HEK 20 15 – 20 6.8 600 700
HEK 25 20 – 25 6.8 600 700
HEK 30 25 – 30 8.1 1,000 1,100
HEK 40 30 – 40 11.7 1,250 1,350
HEK 50 40 – 50 16.0 1,250 1,350
HEK 60 50 – 60 16.0 1,500 1,600
HEK 70 60 – 70 21.3 1,500 1,600
HEK 90 70 – 90 27.9 1,500 1,600
HEK 110 90 – 110 34.9 1,500 1,600
HEK 130 110 -130 34.9 1,500 1,600
HEK 160 130 – 160 42.7 1,500 1,700
HEK 200 160 – 200 49.8 1,500 1,700